SURPASS HOBBY LED Programming Card for 25/35/45/60/80/120A ESC Electronic

Description: SURPASS HOBBY LED Programming Card for 25/35/45/60/80/120A ESC Electronic Speed Controller Motor Set For RC Car Description:1: Low voltage detection is 3.1V, 2.9V, 2.7V, no detection. 2: The start mode is normal, soft, and strengthened. 3: Maximum braking force (25A, 45A, 60A) 50%, 25%, 75%, 100% (default 50%). (80A, 120A) 25%, 50%, 75%, 100% (default 25%). 4: The maximum reversing force is 25%, 50%, 75%, 100%. 5: The width of the center point is 9%, 6%, 12% in sequence. 6: BEC cable connection is connected according to the color direction. 7: The red above 1~5 indicate the default settings of the ESC factory. Programmer operating instructions: a) Connect the BEC cable of the ESC to the programmer. The connection direction is in accordance with the color direction shown above (the black ground wire is on the right frame). b) Connect the power of the ESC and turn on the power switch (80A and 120A should be pressed and held down the ESC button). c) When the programming green LED on the programmer flashes twice and then stays on, it means that the ESC and the programmer are successfully connected. When the programming LED turns off next time, it means that the programmer reads the current programming parameters of the ESC and displays the corresponding LED in the corresponding item. Otherwise, the connection fails. d) Press the down button on the programmer to select among different programming items. The corresponding LED lights of the selected current item will light up in turn, indicating the currently selected item. e) Press the right button on the programmer to select the content that needs to be set in the currently selected item, and the LED light of the selected content will light up. f) Repeat the operations of d and e to select all the content that needs to be set. g) Press the programming button on the programmer to program the content set above to the ESC. The programming LED lights up when programming is started, and turns off after more than 5 seconds to indicate successful programming. Otherwise, programming will fail (reprogram after turning off the power). h) Press the factory button on the programmer to restore the ESC to the factory default settings. The programming LED lights up when programming is started, and turns off after more than 5 seconds to indicate successful programming. Otherwise, programming will fail (reprogram after turning off the power).

Price: 7.97 USD

Location: 深圳

End Time: 2024-02-15T09:28:38.000Z

Shipping Cost: 2 USD